X1 <2025>

To prepare your for its first print, you must first clear all internal shipping restraints and perform an initial calibration. The process typically involves unboxing, removing protective foam, and setting up the software interface. Initial Physical Setup

Once the hardware is clear, the printer needs to "learn" its own geometry and load material. To prepare your for its first print, you

: Unscrew the three screws located next to the lead screws (usually marked with arrows or labels) to allow the bed to move. : Unscrew the three screws located next to

: Ensure you select the correct filament type (e.g., Generic PLA) on the screen before starting. Load Filament : Place your filament spool on

: Clean the plate with dish soap and water to remove oils, then apply a thin layer of glue stick if using the Cool Plate or Engineering Plate for better adhesion. Load Filament : Place your filament spool on the holder or in the AMS.

Select on the screen; the nozzle will heat up and pull the filament through. Your First Print

: Most users start with the 3D Benchy boat found on the built-in storage or the included SD card.