: Plug your receiver outputs into the left side of the board. Follow the pin definitions for Aileron, Elevator, Throttle, and Rudder.
: Power up your transmitter (TX) and FC. Navigate to the "Receiver Test" menu on the LCD. Move your TX sticks and verify the values change correctly (e.g., pushing the stick left should show "Rudder Left"). If they move the wrong way, use your TX's "Reverse" setting. kk2.jpg
: Turn on your transmitter and set the throttle to maximum. : Plug your receiver outputs into the left side of the board
: Hold down Buttons 1 and 4 on the KK2 board and keep them pressed. Power Up : Plug in the drone's battery. Navigate to the "Receiver Test" menu on the LCD
: Connect your Electronic Speed Controllers (ESCs) to the right side of the board. Ensure you use the correct motor layout for your frame type (e.g., Quadcopter X or +).