Delta 52 611 Sander Manual -

: Clean unpainted surfaces (like the table) with a cloth moistened with kerosene to remove protective coatings. Table Assembly :

: Must be secured to a workbench or floor; if using a workbench, drill four 3/8-inch holes to permanently bolt the base. 2. Setup and Installation

Slide the table assembly onto the rod and secure it with the secondary socket head screw. Delta 52 611 Sander Manual

Maintain a minimum clearance of between the table and the sanding belt for safety.

: Overall height of 60", weighing roughly 200 lbs. : Clean unpainted surfaces (like the table) with

: Use a 3-wire grounded extension cord. Ensure the gauge is heavy enough to prevent voltage drops and overheating (refer to the Delta Abrasive Belt Manual for specific gauge charts). 3. Operational Safety 6" Abrasive Belt Finishing Machine

Insert the support rod into the base and tighten the socket head screw. Setup and Installation Slide the table assembly onto

: Tilts 45° out (away from belt) and 20° in (toward belt).